|
|
||||
|
|||||
|
|||||
|
|
||||
|
|||||
|
1. Description
■ Symptom/Condition
On
some cee’d(ED) vehicles, the turn signal switch may not return
after the vehicle completing turning
to
the left side.
■ Cause
Due
to the defective turn signal lamp switch
■ Countermeasure
Inspect
the turn signal lamp switch is defective by identifying the production
date,
and if necessary, replace it according
to the service procedure below.
2. Applicable Vehicles
■ Model : cee’d (ED)
■ Applicable
vehicle production date range: From Jun. 1, 2007 to Oct. 31, 2007
■ Applicable
VIN range: From SU5YFF23428L000002 to U5YFF24428L088475
■ Area : Europe
3. Parts Information
■ PARTS REQUIRED
PART NAME |
PART NO. |
DESCRIPTION |
FIGURE |
Lever Assy – |
934101H100 |
Basic |
|
934101H200 |
Conventional –projection |
||
934101H400 |
Conventional –projection, auto light control system – 1stage |
4. Operation Code And Time
OP CODE |
OP NAME |
OP TIME |
NATURE |
CAUSE |
080S02I0 |
Turn Signal Lamp Switch Inspection |
0.4 M/H |
*N94 |
**C99 |
080S02A0 |
Turn Signal Lamp Switch Inspection and Replacement |
0.4 M/H |
*N94 Inoperative
**C99 Others
5. Service Procedure
■ IGNITION KEY HOLE ILLUMINATION INSPECTION
1) Verify that the vehicle is an affected one by identifying the VIN. 2) Start the engine, and then stop it by turning the ignition key to the “OFF” position 3) Place the ignition key to the “ON” position within 2 seconds without starting the engine. Note) Steps 2 to 3 are to let the steering wheel
turn with the ignition key on. |
||||||||||
4) Locate and unfasten the 3 lower shroud mounting |
||||||||||
5) Remove the upper shroud (C) first using a |
||||||||||
6) Let the lower shroud droop. |
||||||||||
7) Remove the turn signal lamp switch by pushing the lock pin (D). |
||||||||||
8) Disconnect the wiring connector (E) from the turn |
||||||||||
9) Verify the turn signal lamp switch production
date (F) on the bottom of the switch is within the affected range according to the table. |
||||||||||
10) If the production date is within the affected range, replace the turn signal switch with newly improved one and install all the removed components in reverse order of removal. But, if not, no turn signal switch replacement is needed. Re-install all the removed components in reverse order of removal. |